Qwickset Push Button Door Lock Blicks Red And Doesnt Work

Press the latch bolt.

Qwickset push button door lock blicks red and doesnt work.

The master pin code can still be used to unlock the door. When a user attempts to enter a pin code when the lock is in lock out mode the status indicator flashes red and blue. Hold the handleset on the exterior side of the door and make sure the round edge of the spindle faces the door edge. Reinstall the door knob and test.

Keep holding the button for 30 seconds until the lock beeps and the status led flashes red. The door handing process was not executed during installation. Press and hold the a or program button while reinserting the battery pack. If it is not pull the spindle out and rotate 180 degrees.

On my smartcode 909 910 the lock beeps the keypad flashes red and the door cannot lock. All code lock out mode is a feature in which the lock rejects all user codes. If this doesn t work you need to remove the knob again. Hold button until the latch bolt starts moving on its own.

Make sure the turnpiece is in the vertical position. Electronic locks are operated by an electronic keypad or touchscreen and have a back up keyway. View button locations for your lock model. Press and hold the lock button while installing battery pack.

Here are the instructions for the door handing. Step 3 pull out the battery pack and push program three times if the smartcode fails to initialize after battery removal and re installation. The spindle is spring loaded and will retract back when released. Inspect the inside for signs of rust.

Press the button once more. The keypad flashes at the same time.