Remove Arm Rest Door Grab Handle 2010 Toyota Corolla

Pull the little phillips clip out on the side of the door panel.

Remove arm rest door grab handle 2010 toyota corolla.

Remove the triangular panel at the top inside corner of the door panel. Use a putty knife to unpin the door panel from the door. Quickly and easily installed it eliminates the clunking noise that may result when this part fails while restoring original ride control. Car and truck interior door handles for toyota corolla.

Door arm rests by dorman. Move to the door pull handle well in the arm rest and pry open the round screw cover. Pry up the switch panel. First you remove the inside door handle again unclip the plastic clip make sure when you put the door back together that this clip gets back on.

The corolla is a sedan designed by toyota that is slightly smaller than the camry. Then with a flat head screw driver you lift up the arm rest piece to expose the two screws holding the arm rest to the door. Dorman has all the components needed for a complete repair. Then you remove the triangle plate for the outside mirror.

Simple and detailed instructions to make this job simple enough for anyone to do. 2 screws trim panel. Remove and set aside the door handle. Pull up the armrest panel and remove the exposed phillips screws.

Then remove the single screw behind the door opener handle with the phillips head screwdriver by turning it counter clockwise and set it aside in a safe place.