Remove Jeep Doors With Power Windows

3 on a manual window use the crank to roll down the window halfway to give you access to the bolt that.

Remove jeep doors with power windows.

If you need more information on how to do that check out the door panel removal video. Be careful not to damage the paint. Use a 13 mm socket and turn counter clockwise to loosen the nuts. Simple 3 wire hookup.

With the other hand grip the outside door handle. It s also beneficial to lube the door stems and hinges when the doors are removed in order to make future removal easier. One power wire goes to the battery one goes to an ignition power source and the third gets grounded in the kick panel. Be careful with the paint on the door hardware.

This can be done with a t50 socket and ratchet. The nuts are painted to match the body of the jeep so be very. See more information on our jeep wrangler power window kit power door lock kits. At the bottom of each of the two bolts that hold each door on the.

Instructions 1 remove the door panel. Heavy duty connectors are installed allowing doors to be removed. Roll down the windows remove the door check arm unplug the wiring drop the two hinge bolts pull off the limit strap and lift it free. Removing the doors 1.

The first step in the removal of jeep doors is to loosen and remove the t50 cap nuts on the door hinges. The process is basically the same for the front and rear. Lift the door straight up to disconnect it from the jeep. 2 pull or cut out the glued door seal to allow access inside the door.

Lift the door straight up to disconnect it.