If the fixed side of the sliding glass door is held up by a metal strip that attaches to the door jamb remove it.
Removing a sliding door lock.
These are the parts used.
The sliding glass door latch is located in the center of the frame of the door where it closes.
Unlock the sliding glass door and open it.
Once you remove all the screws lift the door up and make sure that it is completely removed from the bottom track of the door frame.
Prime line products c 1225 sliding door handle mortise st.
Unscrew this plate and remove the latch from the door if possible.
Taking the door out of the track 1.
Your lock is most likely the e2014 or the e2013 shown on my sliding door lock page.
Slip a flat screwdriver underneath the wheels and push them upwards.
On the e2014 the actuator lever is at an angle of 45 degrees.
How to change an old mortise lock handle patio door with new 2019 parts.
Step 2 screw removal.
Usually its the e2014 but the only way to be absolutely sure is to loosen the two screws that hold the handle on.
Pushing the wheels up will make it easier to.
Enjoy the videos and music you love upload original content and share it all with friends family and the world on youtube.
Pull the door up from the bottom track until the wheels are out.
4 removing the sliding door before removing the door slide it to the point in the track where you see an indent.
How to remove a door lock without a key.
Remove the handles from the door using a philips head screwdriver.
The sliding glass door latch is often connected to the metal sliding glass door frame with a series of screws.
Remove this screw using a drill or screwdriver.
Then replace the bottom screw in the hole where it was affixed to the handle to prevent the latch from falling into the doorframe.
At this point the square tab on the spindle is aligned with the square.
Look for a small set screw at the base of the handle.
Then tilt it slightly with help and remove it from the upper track of the door frame as well.
Step 3 removing the screws two screws on the end of the door secure the latch.
Use the flat head screwdriver to turn the spindle in the center of the door lock cylinder counterclockwise until it stops.
Open the door and look for the latch plate along the door s edge.
Look on the edge of the sliding glass door to locate the sliding glass door lock.
Remove the screws that hold the fixed door in place in the sliding door tracks.