Removing Door Handle Small Hole

Apply a bit of pressure to the paper clip to trigger a release button inside the hardware.

Removing door handle small hole.

Remove the plates from either side of the door and set them aside as well. Push the tip of a narrow screwdriver into the hole. Once triggered the lever or lock trim can be removed from the door. Pull out the latch plate and door latch mechanism.

So carefully insert the flathead beneath the plate and begin to pry the cover away from the door. After you ve unscrewed or loosened the latch tug on the door knob until it pops out of place or disengages from the base also known as the rose. You should see a tiny slot or hole. Look on the neck of the inner doorknob for a slot or hole between the back of the doorknob and the door.

How to remove a door knob without screws or a latch. Look for a recessed slot in the shaft of the handle. If there s one present you ll be able to depress a button or loosen a small screw inside the hole to release the handle. Against the door where that notch is located will be a very small section where you can insert a flat head screwdriver.

You should now just have holes in your door into which you can install a new door handle. Open the door so that you can access both the inner and outer doorknobs. If your door has no visible screws check the neck of the knob or lever for a small hole. Step 2 straighten a large wire paper clip out and insert one end into the hole until you feel the spring loaded retaining pin.

Look for pin holes in the rose or in the lever body itself. Straighten a paper clip and insert it into the hole. Keep in mind that you only need a very small amount of separation.