Removing Door Panel On 2011 Silverado

Lift the door panel up and off.

Removing door panel on 2011 silverado.

Disconnect the switch wiring harnesses. Now pry off this panel. Pry up the window switch panel. Pry out the door panel with a door panel clip tool or putty knife.

Use a 7 mm socket wrench or a ratchet extension and 7 mm socket. Remove the door panel push pins and trim screws. Now reach in behind your door panel and just pull out to release the clips. Remove all door panel electrical connectors.

Remove the two 10mm bolts underneath the handle. Lift the door panel up and out to release the door panel locking tabs. Move to the bottom edge of the door panel carefully insert a flathead screwdriver or an automotive trim panel removal tool and gently pop out the friction fasteners. Just pull out the clips on the back.

Continue pulling on the bottom and sides of the panel to disengage all of the white plastic friction fasteners. Remove the panel under the handle. 2011 chevrolet silverado 1500 134 10. Remove the door handle bezel by inserting a flat trim removal tool between the door panel and handle bezel to release the locking tabs.

Now you want to remove this 10mm bolt and these two 10mm bolts right here. Remove the two 10mm bolts inside the door pull. You need to remove the 2 bolts that hold the pull handle on there is 1 bolt behind the door handle that opens the door and there are 2 behind the handle that is directly behind the switches. How to on removing the door panel and replacing the inside door handle on dads 2013 gmc sierra 2500hd.

Then pull the door panel starting at a lower corner and lift the panel up. Disconnect the latch cables from the door handle with pliers. Life the lock up and off. Remove the 10mm bolt inside the door handle.

Then you want to do the same thing to the panel on the other side. 2011 door panel removal. 07 13 chevrolet silverado 1500 door panel rear right passenger black 1119 06 fits. Also replaced the door handle cable.

Gently lift panel up. Start off by prying up this panel behind the pole handle and then pry out this little panel beyond your door handle. We ll fast forward as don does this. Locate and remove the door panel retaining screw underneath the rear of the window control module cavity.

Pull the lock up and pry out the panel on the lock. Jan 24 2013 1 58pm i believe there s a little pin on the underside of the base on the inside release handle that when you push up it should pull right off. Free shipping on many items.